Slide Combinations

Wide slide (1,20) with starting platform 0,20 0-41832-701

Classic

Technical data
Area: 1,75 x 3,60 m
Minimum space: 4,75 x 7,10 m
Platform height: 0,20 m
Slide installation height: 0,20 m
Slide entrance height: 0,30 m
Slide installation height above
slide run-out section level zero: 1,20 m
(for a hill height of 1,00 m)
Slide inclination: 36°
Slide width: 1,10 m
Sliding sheet metal thickness: 2,5 mm

Posts
Laminated Robinia timber Ø 120 mm with cylindrical milling. End-grain surfaces are covered by non-detachable protective stainless steel caps.
Stainless steel tubular pedestal for concrete-cast foundation and for fixed mounting to round Robinia posts, Ø 120 mm, below playing surface.
Posts flush with platform level are made from stainless steel, covered by welded round plates.

Platform
Platforms from boards of 30 mm thickness and all-round square-shaped joists 45 x 100 mm. Dried timber from Robinia, planed, milled and free from decay. Force-fitting fastening through specific stainless steel brackets with end-to-end bolt assembly.

Attachment parts
– attachment slide, width 1,10 m, one-piece welded assembly, stainless steel sheet thickness: 2,5 mm, with roll-off prevention above the entrance section

For your planning, due to a possible sliding surface heating, please see to a north-east orientation of the slides or provide half-shade of trees.

Robinia timber is furnished with water-repellent, breathable protective coating. Besides protection from moisture, that treatment reduces crack formation. Thanks to a specific fastening adaptor, forces arising from the modular attachment parts are directly derived into the posts. Tamper-proof screw connections thanks to screws with protective screw caps.

Foundations (on site)
4 pcs. 0,40 x 0,40 x 0,40 m
1 pc. 0,40 x 1,25 x 0,40 m
concrete amount: 0,46 m³

Approximate assembly values
2 mechanics 2 hours each
(without creating foundations)

Free height of fall
Platform: 0,20 m
Slide: Depending on the site profile, the free fall height and the size of the impact area result from the vertical distance between the bottom of the chute and ground level. The surfacing material for the impact area within the sliding section must meet the requirements given in table 4 (see EN 1176-1). The shock-absorbing characteristics of any other material to be chosen must be certified in accordance with EN 1177. The surface around the run-out section shall have a critical fall height of at least 1000 mm and shall be provided to at least 2000 mm beyond the run-out section (acc. to EN 1176-3).

Appropriate for
children from the age of 3 years up,
public playgrounds etc.,
physical activity

For more information please contact us