Technical data
\nFloor area: 6.25 x 6.40 m
\nMinimum space: 9.25 x 9.40 m
\nPlatform heights: 0.60\/0.80 m<\/p>\n
Support post
\nStanding posts made of robinia plywood, cylindrically milled, \u00d8 120 mm. Unprotected end grain surfaces are covered with non-detachable stainless steel post caps.
\nStainless steel tubular base for the foundation and elevation of Robinia roundwood posts, \u00d8 120 mm, below the play level. <\/p>\n
Platform floor
\nPlatform floor made of boards, 30 mm thick and circumferential squared timber beams 45 x 100 mm. The dried sawn timber made of robinia is planed, bevelled and free of rotting knots. Force-fit floor fastening using special stainless steel brackets with a continuous bolt connection. Pump pedestal also with profiled stainless steel sheet and prepared for installation of the valve combination included in this water feature. The valve combination will be located directly below the pump platform. An additional shaft for the valve combination is therefore not required.<\/p>\n
Attachments
\n- Railing bracket, anti-roll, made of stainless steel tube, \u00d8 33.7 x 2 mm
\n- Tandem railing made of stainless steel tube, \u00d8 33.7 x 2 mm
\n- Access railing, roll-preventing, made of stainless steel tube, \u00d8 33.7 x 2 mm, consisting of horizontal railing tube and balustrade tubes arranged vertically on both sides
\n- Wooden balustrade made of robinia, 125 x 30 mm, fastened between stainless steel tubes \u00d8 33.7 x 2 mm
\n- Climbing rung (cranked) made of stainless steel tube, \u00d8 33.7 mm
\n- Climbing rung made of stainless steel tube, \u00d8 38 x 2.5 mm, twist-proof<\/p>\n
Water pump with handwheel Article no. 0-33131-001
\nWater pump for direct connection to a water pipe, suction pipe connection 1 \u00bc inch (pipe diameter at least \u00be inch)
\nWelded stainless steel construction, encapsulated pump housing, pump mechanism with roller and plain bearings, upper pump housing with handwheel must be removed, e.g. during the frost period.
\nCover (\u201ewinterisation plate\u201c) for the remaining pump base is supplied.<\/p>\n
Valve combination 1 1\/4\u2033 with hygienic flush (installed below the platform floor)
\nDevice for direct connection of the water pump to a pressurised water pipe with fine filter for cleaning the water of suspended matter, dirt particles, etc., in order to prevent the diaphragm valves from becoming contaminated and thus prevent malfunctions.
\nIncluding K&K hygienic flushing: Device for automatic flushing of the pipework between the valve combination and K&K water pump with timer and non-return valve, designed for flushing a maximum of 30 m DN 40. Control unit consisting of control module, waterproof welded-in 6 V battery. Hygiene flush set to a 12-hour cycle at the factory.
\nThe valve combination should be connected by a specialised installation company.<\/p>\n
Water reservoir
\nBase area: \u00d8 0.86 m
\nWelded stainless steel construction with 1 water drain pipe. Rubber cone closure with locking mechanism for complete water drainage. Sheet thickness: min. 2 mm \/ pipe \u00d8 38 mm. Connection to post.<\/p>\n
Y-channel
\nY-shaped water channel with one inlet area and two outlets, sheet thickness: min. 2 mm \/ pipe \u00d8 38 mm.
\nIncluding 2 storage flaps, freely positionable, stainless steel handle, rubber blade with fabric insert.<\/p>\n
Water channel 0.80 m, 2 pieces
\nWelded stainless steel construction. Sheet thickness: min. 2 mm \/ pipe \u00d8 38 mm. Bevelled spout.
\nStepless inclination for installation for the required gradient for the water inlet and outlet through additional elevation.<\/p>\n
Water channel 1.60 m
\nWelded stainless steel construction. Sheet thickness: min. 2 mm \/ pipe \u00d8 38 mm. Bevelled spout.
\nStepless inclination for installation for the required gradient for the water inlet and outlet through additional elevation.
\nIncluding storage flap, freely positionable, stainless steel handle, rubber blade with fabric insert.<\/p>\n
Water distribution table (0.75) Article no. 0-33481-000
\nTotal height: 0.90 m
\nWelded stainless steel construction with 2 water drain pipes. Rubber cone closure with locking mechanism for complete water drainage. Sheet thickness: min. 2 mm \/ pipe \u00d8 38 mm. Matching ring foundation (15166) for anchoring to the flange ring and moulded stones (15167) for bricking up and levelling height differences or for secure foundation in loose fall protection (sand, fine gravel, etc.) can be supplied at an extra charge.<\/p>\n
Conveyor basin solitary
\nWelded stainless steel construction with mounting device for the base bearing of the water spiral. Water inlet directly below or above the pipe ring. Sheet thickness: min. 2 mm \/ pipe \u00d8 38 mm. Water outlet opening closed by cylinder screw. Matching ring foundation (15168) for anchoring to the flange ring and moulded stones (15169) for bricking up and levelling height differences or for secure foundation in loose fall protection (sand, fine gravel, etc.) can be supplied at an extra charge.<\/p>\n
Water spiral (2.00) Handwheel drive and top turntable
\nSpiral length: 2.00 m
\nOuter diameter: 0.25 m
\nWelded stainless steel construction with roller bearings, screw-on foot bearing.<\/p>\n
Modular catch basin
\nWelded stainless steel construction for water absorption with drain pipe. Sheet thickness: min. 2 mm \/ pipe \u00d8 38 mm. For connection to posts.<\/p>\n
Water channel type 1.60 m \/ water wheel 0.60 m
\nWelded stainless steel construction with elevation and water channel. Sheet thickness: min. 2 mm. Water wheel consisting of 12 blades, folded flat at the front and enclosed by side walls. Wheel bearings with maintenance-free roller bearings. <\/p>\n
Metal components: Stainless steel. The robinia wood is treated with a water-repellent, breathable protective coating. In addition to protecting against moisture, this treatment also reduces cracking. The modular add-on parts transfer their forces directly to the uprights via a special adapter fastening. The screw connections are secured against unauthorised loosening by cover caps.<\/p>\n
Foundations (client-provided)
\n21 units 0.40 x 0.40 x 0.40 m
\n 6 pcs. 0.50 x 0.50 x 0.50 m<\/p>\n
Assembly time
\n2 fitters 8 hours each.
\n(without foundation, without water connection)<\/p>\n
Free fall height
\n1,15 m<\/p>\n
Suitable for
\nChildren aged 3 and over,
\npublic playgrounds etc.,
\nManual activities<\/p>\n
Item number: 034370700<\/p>","protected":false},"excerpt":{"rendered":"
Technische Daten Grundfl\u00e4che: 6,25 x 6,40 m Mindestraum: 9,25 x 9,40 m Podesth\u00f6hen: 0,60\/0,80 m Standpfosten Standpfosten aus Robinienschichtholz, zylindrisch gefr\u00e4st, \u00d8 120 mm. Ungesch\u00fctzte Hirnholzfl\u00e4chen sind mit nicht l\u00f6sbaren Pfostenkappen aus Edelstahl abgedeckt. Rohrstandfu\u00df aus Edelstahl zur Fundamentierung und Aufst\u00e4nderung von Robinien-Rundholzpfosten, \u00d8 120 mm, unterhalb der Spielebene. Podestboden Podestboden aus Brettern, 30 mm […]<\/p>\n","protected":false},"featured_media":544499,"comment_status":"closed","ping_status":"open","template":"","meta":{"_acf_changed":false,"_et_pb_use_builder":"","_et_pb_old_content":"","_et_gb_content_width":""},"product_brand":[],"product_cat":[84],"product_tag":[],"class_list":["post-427811","product","type-product","status-publish","has-post-thumbnail","product_cat-sand-wasser","pa_altersgruppe-81","pa_hebezeug-false","pa_inklusionsattribute-dramaspiel","pa_inklusionsattribute-einzelspiele","pa_inklusionsattribute-erforschendes-spiel","pa_inklusionsattribute-feinmotorik","pa_inklusionsattribute-fuehlen","pa_inklusionsattribute-gruppenspiele","pa_inklusionsattribute-hoehenerfahrung","pa_inklusionsattribute-kommunikation","pa_inklusionsattribute-koordination","pa_inklusionsattribute-paralleles-spielen","pa_inklusionsattribute-selbstwahrnehmung","pa_inklusionsattribute-tasten","first","instock","purchasable","product-type-variable"],"acf":[],"yoast_head":"\n